VELOSTER(FS) >2013 > G 1.6 T-GDI > Engine Mechanical System > Cylinder Block > Rear Oil Seal>Repair procedures  
Removal
1.
Remove the transaxle assembly.
(Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")
2.
MT : Remove the flywheel.
(Refet to Cylinder Block - "Flywheel")
3.
AT : Remove the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Remove the rear oil seal(A).

Installation
1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.
MT : Install the flywheel.
(Refet to Cylinder Block - "FlyWheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")